There's a round timing gear cover plate on front of engine, remove that cover plate to access timing gear retainer bolt #24 and remove bolt. In an emergency however, if the timing marks are clearly marked on the engine and pump mounting flange, most. Since the procedure may vary depending on the engine please refer to the correct engine service manual for your engine. These are basic instruction for the timing and installation of the Delphi (C.A.V., Lucas) DPA model pump. If you have got fuel to the bleed screws on the pump,slacken off the injector pipes and see if you are getting fuel up to the injector,make sure that you have got all the air out of the system.Put plenty of fuel in the tank.Have you got a lift pump fitted? Recheck your timing on No 1 cylinder, injection should be around 23 deg before TDC. Been a while since I've timed a CAV/Lucas injection pump, bear with me. Fires right up after using the glow plugs when cold, but after she is warm, it takes right off. I might note that the timing gear marks can be a bit deceiving due to the idler between the crank gear and the injection pump drive gear.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |